LED PCI Backlight Mod
This is a pretty easy (and cheap) way to get that neat backlight effect without having to do any severe cutting of the case.
Stuff and tools needed:
2 empty card slots (Type of slot doesn’t matter since I’m only going to use the empty space)
4 LED’s - 3V (Check this site before buying!)
Wire
Some sort of power switch
1 Molex male connector (you get it from radio shack or an old PSU)
Soldering iron
Soldering wire
Drill
Glue
Electric Tape (duct tape will also work)
Various Pliers
Puncher
Hammer
Well, to begin with I open up the computer I’m going to modify and take out 2 of the
PCI-slot covers. Then I measure up the distances between the holes for the LED’s that I’m going to drill. I found out that putting the holes with approx. 2 cm distances works quite well.
Use a ruler and a non-permanent marker! Here you can see how I marked out where to drill.
![](pcilight00.jpg)
Use a puncher to make drilling easier.
![](pcilight01.jpg)
Drill! Since my LED’s where 5 mm ones, I’ll have to drill two times, first with a 3 mm drill, then with a 5 mm drill.
![](pcilight02.jpg)
After the holes were made, I put in the LED's and glued them in place to make soldering
easier.
![](pcilight03.jpg)
Solder! Make sure you get the polarity right. After this it gets real simple, just drill the hole for the switch in the other cover, and solder all the
wires.
![](pcilight04.jpg)
Here's the wiring schematics...
![](schematics.gif)
Finished! Doesn't it look nice?
![](pcilight05.jpg)
Here you can see how I installed it....
![](pcilight06.jpg)
And here's how it looks like when turned on....
![](pcilight07.jpg)
Happy Modding
- Guide written by Sebastian Storholm
|